SWG

Weather-resistant galvannealed steel cabinet with powder coat finish
Lockable, gasketed and removable front cover for easy access

Heavy-duty 60:1 right-angle C-face gear reducer
Heavy-duty gate arm assembly with harmonic design for smoother starts and stops
Over-center gate arm "locking" angle
#40 roller chain and sprockets
Adjustable torque limiter
Heavy-duty pillow-block bearings

Operator is pre-wired to accept contact and non-contact detection devices such as contact edges and/or photo electric eyes

1/2, 3/4 or 1 HP, 115 or 230 VAC, single phase, thermally protected, heavy duty C-face PSC motor; 1/2, 3/4 or 1 HP, 230 or 460 VAC, 3 phase heavy duty motor
Power on/off switch
Emergency stop/reset button on front cover
Duplex receptacle on 115 VAC units
Three-button control station included
Accessory connections are 24-volt AC or DC
Easily adjustable rotary limit switches
Full system capable for access controls and reversing devices

Solid state circuit board, 24 VDC
Inherent current sensing system
15 LEDs for easy setup and troubleshooting
Built in maximum run timer and auto close timer
Right-hand/left-hand easy conversion
Master/Slave - simple three-wire connection
Entrapment Alarm

Continuous tone entrapment alarm
Warning beeper to sound when gate is moving
Pre-start audio/visual outputs included

SWG SERIES SWING GATE OPERATOR SPECIFICATIONS
Model	HP	Voltage-Single Phase (Voltage-Three Phase)	Maximum Gate Width	Maximum Gate Weight	Seconds to Open Gate	Shipping Weight

SWG-2	1/2	115/230V (230/460V)	18'	700 lbs	15	275 lbs
SWG-4	3/4	115/230V (230/460V)	22'	900 lbs	15	275 lbs
SWG-1	1	115/230V (230/460V)	26'	1000 lbs	15	275 lbs

Caution: Automatic gates are not for pedestrians! Automatic gate operators are designed for vehicular traffic only. They are powerful and can cause serious injury or death. Accordingly, direct all pedestrian traffic to a separate pedestrian gate. UL325 requires the use of contact or non-contact anti-entrapment devices.